Radio Systems CT-2002 Operations Instructions download pdf (Page 5)

Radio Systems, Inc. CT-2002 Manual

Page 5

General Operating Instructions

For all non GPS or master units (applies to units utilized in stand-alone

and slave display capacities.)

Time-of-Day Set Up and Up-Timer functions can be controlled by the front panel

buttons or the wired remote control. However, the IR Remote Control must be

used for entering down times and internal setup functions.

Front Panel or Wired Remote Operation

Clock/Timer (Mode) Select

All CT-2002 units operate as both clocks and timers. Switch between modes by

pressing the MODE button on the front of the unit. The front panel LED’s will light

to indicate the mode selected.

Note that on the CT-2002 large wall display models, the mode switch is available

on the remote control only. The fourth front panel switch is used to put the clock

into the set mode.

To Set the Clock:

Note: If Serial Time of Day is supplied to the CT-2002 (slave mode), it will not be

possible to enter the Time-of-Day set mode. Setting the time-of-day can either be

done at the master unit or the displayed hours can be offset via the IR Remote

Control.

1. Press the mode button to select the Time-of-Day display. The Clock LED will

illuminate.

2. (Desktop and Thin models) - press and hold the STOP and START buttons.

The Set Led will illuminate.

(Large models) - press the SET button. The Set Led will illuminate.

3. Display resets to 12:00:00

4. Press the STOP button to advance the hours. Press the RESET button to

advance the minutes (note - seconds are not setable and remain at :00).

5. Start the clock at the top of the minute by pressing the START button.

The Set Led will extinguish.

To Use the Up Timer:

(To utilize as a Down-TImer consult IR Remote Control Instructions page 8)

1. Press the Mode Button to select the timer display. The Timer Led will

illuminate.

2. Press the START button to start timing.

3. Press the STOP button to stop timing.

4. Press the RESET button to return the display to 00:00.

1 2 3 4 5 6 7 8 9 10 ... 27 28

No comments

Radio Systems CT-2002 Operations Instructions Page 5